ASME BPVC IX - Welding, Brazing and Fusing: 2023 [paper]

This Segment contains rules connecting with the capability of welding, brazing, and melding methods as expected by other BPVC Areas for part fabricate. It also covers rules relating to the qualification and requalification of welders, brazers, and welding, brazing and fusing machine operators in order that they may perform welding, brazing, or plastic fusing as required by other BPVC Sections in the manufacture of components. Welding, brazing, and fusing data cover essential and nonessential variables specific to the joining process used.

Key changes for ASME BPVC-IX:

• QG-108 has been revised to remove the 1962 provision and clarify the status of old PQRs when writing a WPS to a later edition.
• Definition of “initial heating interfacial pressure” was added was added to QG-109.2 and previous omissions of “sidewall-fusing” was added to pertinent definitions within QG-109.2.
• Table QW-264 has a new requirement that includes carbon equivalent limits for applicable steel alloys, when laser welding is performed, in order to address the increased risk of any cracks occurring.
• A new paragraph in QW-403 also includes the new variable for a change in base metals.
• Table QW/QB-422 has been revised to include: Weld metals based on SFA classification: SFA-5.9, SFA-5.18, & SFA-5.28; An explanatory note-QW-424.3; Base metal specification and grades for IRAM-IAS U 500-42, an Argentinian standard for structural use of hot rolled carbon steel sheets.
• Nonmandatory Appendix L has been revised to further clarify the qualification requirements for welders and welding operators.

ISBN: 9780791875858, ASME BPVC IX_2023