AWS A5.34/A5.34M: 2013 [paper]

AWS A5.34/A5.34M: 2013 [paper]

Specification for Nickel-Alloy Electrodes for Flux Cored Arc Welding, 2nd edition.


verstuurd binnen 3-5 dagen







Artikelnummer: 1038667
Verstuurd binnen 3 tot 5 dagen
Levertijd:: verstuurd binnen 3-5 dagen
Soort:: Boek
Taal:: Engels
ISBN: 9780871718372
Artikelnummer: 1038667
  • Vandaag verzonden: mits vóór 15:00 uur besteld en op voorraad
  • Officiële distributeur van IATA, IMO en ICAO
  • ISO 9001 gecertificeerd, alleen 100% klanttevredenheid is goed genoeg
  • Uitgebreid assortiment. Niet gevonden? Wij regelen het voor u!
  • Behulpzame klantenservice voor al uw vragen!



AWS A5.34/A5.34M: 2013 – Specification for Nickel-Alloy Electrodes for Flux Cored Arc Welding, 2nd edition

This specification prescribes requirements for the classification of nickel-alloy electrodes for flux cored arc welding. It includes those compositions in which the nickel content exceeds that of any other element, but excludes nickel-base alloy compositions intended for the joining of cast irons.

Safety and health issues and concerns are beyond the scope of this standard and, therefore, are not fully addressed herein. Some safety and health information can be found in the nonmandatory annex, Clauses A5 and A10. Safety and health information is available from other sources, including, but not limited to, ANSI Z49.1, Safety in Welding, Cutting, and Allied Processes, and applicable federal and state regulations.

This specification makes use of both U.S. Customary Units and the International System of Units (SI), according to the guidelines in AWS A1.1. The measurements are not exact equivalents; therefore, each system must be used independently of the other without combining in any way when referring to material properties. The specification with the designation A5.34 uses U.S. Customary Units. The specification A5.34M uses SI Units. The latter are shown within brackets [ ] or in appropriate columns in tables and figures. Standard dimensions based on either system may be used for sizing of filler metal or packaging or both under the A5.34 or A5.34M specification.